CHINESE JOURNAL OF AERONAUTICS
Review
Fluid Mechanics and Flight Mechanics
- Optimization and design of an aircraft’s morphing wing-tip demonstrator for drag reduction at low speed,Part I–Aerodynamic optimization using genetic,bee colony and gradient descent algorithms
- Optimization and design of an aircraft’s morphing wing-tip demonstrator for drag reduction at low speeds,Part II-Experimental validation using Infra-Red transition measurement from Wind Tunnel tests
- Developing an engineering-statistical model for estimating aerodynamic coefficients of helicopter fuselage
- An experimental system for release simulation of internal stores in a supersonic wind tunnel
- Flutter analysis of hybrid metal-composite low aspect ratio trapezoidal wings in supersonic flow
- A coupling VWM/CFD/CSD method for rotor airload prediction
- Effect of Coriolis and centrifugal forces on flow and heat transfer at high rotation number and high density ratio in non orthogonally internal cooling channel
- Discretized Miller approach to assess effects on boundary layer ingestion induced distortion
- Influence of coupled boundary layer suction and bowed blade on flow field and performance of a diffusion cascade
- A novel surface mesh deformation method for handling wing-fuselage intersections
- Experimental investigation on a cavity-step-actuated supersonic oscillating jet
Solid Mechanics and Vehicle Conceptual Design
Electronics and Electrical Engineering and Control
- Identifying vital edges in Chinese air route network via memetic algorithm
- Identification of reduced-order model for an aeroelastic system from flutter test data
- Formation tracking control for time-delayed multi-agent systems with second-order dynamics
- Start-up current adaptive control for sensorless high-speed brushless DC motors based on inverse system method and internal mode controller
- Multi-EAP:Extended EAP for multi-estimate extraction for SMC-PHD filter
- Drogue detection for autonomous aerial refueling based on convolutional neural networks
- Relay selection in cooperative communication systems over continuous time-varying fading channel
- Automatic landing system using neural networks and radio-technical subsystems
- Angular velocity determination of spinning solar sails using only a sun sensor
- Spacecraft attitude maneuver control using two parallel mounted 3-DOF spherical actuators
- An adaptive attitude algorithm based on a current statistical model for maneuvering acceleration
Material Engineering and Mechanical Manufacturing
- Drilling load modeling and validation based on the filling rate of auger flute in planetary sampling
- Stress analysis and damage evolution in individual plies of notched composite laminates subjected to in-plane loads
- Anti-plane problem of four edge cracks emanating from a square hole in piezoelectric solids